Headlight Mould

High beam mould, fog light mould, low beam mould, turn signal mould, light distribution mould, reflector mould

Rear headlight Mould

Night light mould, turn signal mould, brake light mould, reversing light mould, light distribution light mould, light guide mould

In the design of the gating system of the automotive light mould, the cold slug well must be designed, and gate types with larger cross-sections such as side gates and fan gates should be used, and attention should be paid to prevent excessive stress near the gate.

In response to the special requirements of automotive light products, poor exhaust in any part of the automotive light mould will seriously affect the appearance of the product: black spots, transparency.

The uniformity of mould temperature and cooling will directly affect the transparency and uniformity of the final product.

Because of the transparency and appearance characteristics of the automotive lights, no traces are allowed on the non-assembly surface, including thimble marks. This kind of product basically uses the peripheral top block type to eject, and all the top block marks are in the assembly range of the counterpart. Inside, it will not have any impact on the appearance requirements of the product

The text engraving on the automotive light moulds is different from the general mould. If the text is engraved on the front mould, the text needs to be reversed, because people view the text content from the product appearance